brother steve
New Member
Anyone come up with a creative way to put fuel filters or just one on there bike. I do like to use two and there isn't much room either . Just thought someone has a good idea to share. Thanks!
ct fuel filters
- Thread starter brother steve
- Start date
hornetgod
Well-Known Member
Those filters are what I use on my Trail 70's with steel tanks.
theraymondguy
Well-Known Member
I use something very similar. Because of the carburetor I have, I use a Y adapter on the supply lines, then single line to filter, then remote petcock (16950-ZM0-003) Amazon.com: Honda 16950-ZM0-003; PETCOCK ASSY. Made by Honda: Patio, Lawn & Garden, then into the carb. Honda's inline filters are VERY dear, so aftermarket is just fine.
Last edited:
birdmannn101
Member
I have these on my bikes. Found them at O'Reiley's. They are called Prime Line 7-02357-1 which is probably the same filters cjpayne mentioned.
theraymondguy
Well-Known Member
I'd have to agree, I though the fuel line on a z was 1/8? It's been a while since I played with one but seems to me they were smaller.
cjpayne
Well-Known Member
When I fit one on my daughters Z50, it was a little tight, but worked. I also got thick gas line for it.
Last edited:
hornetgod
Well-Known Member
Fuel line that's 3/16th inside diameter is the closest to stock for CT70's. The 1/4" in-line filters will work with 3/16th line but, it can be a tight fit.
INLINE FUEL FILTER 1/13M (GASFILTER)
INLINE FUEL FILTER 1/13M (GASFILTER)
Adam-NLV
Well-Known Member
View attachment 20528
Here's a prototype of an idea I had a while back.
These are dual in-line fuel filters. I ended up taking it off and modifying it some more but never re-installed it on my bike. Maybe I'll finish it up someday..
Last edited:
toasterknight
New Member
I used a little bag balm on the filter to make it easier to get the line on. It was tight enough it will probably never leak even without clamps.