Recent content by Jd87

  1. J

    Quiet exhaust

    Thanks I will look into it. I don't mind loud I just don't want any excuse to get pulled over.
  2. J

    Quiet exhaust

    I just got my 108 together and put a two brothers pipe on I had laying around. It sounds pretty good for a off road pipe but waaayyy to loud for the street. I need a pipe that is quiet enough for the street but flow just enough to let the 108 breathe. I don't care if it's louder than stock but I...
  3. J

    3 up

    Just thought I'd give a update...I got the 108 together and with it running it shifts fine. Just messing with the carb to get her dialed in. I went with the tb20mm carb since it's just for street.
  4. J

    Any cylinder head rebuilders or recommendations

    I found an automotive machine shop that also does dirtbike heads. Might check if there is any automotive machine shops around you and take the head down there. The last ct head I had done was $50 in labor plus guides and valves.
  5. J

    3 up

    I was rotating the shaft on the clutch side the whole time. I think What I remember had to make the forks a couple thou narrower where they ride on the drum in order to use ct cases. I can't find that thread again.
  6. J

    3 up

    Alright I put the complete xr50 tranny in it. I used xr gears, starter spindle, and drum with the ct70 shift shaft. I put everything together minus the crank to see if it worked and it did. Well kinda. I turned the primary and ran thru the gears but it seemed to cach in between the gears at...
  7. J

    3 up

    Ok. I think I have all the xr tranny parts. I'll just swap the whole thing. Thank you!
  8. J

    3 up

    Will a shift drum from a xr50 fit in k1 ct70 tranny to make it 3 up shifting? Could I use the xr drum with the ct forks and ct gears? Thanks
  9. J

    Ways to fix stripped carb cap threads on carb

    Is there enough meat on the cap to drill and tap it for a set screw? If there is put two in the cap and dimple the carb so it can't go anywhere.
  10. J

    Dim headlight

    At the moment this one from dratv.
  11. J

    Dim headlight

    Here is a picture of the stator and wire colors like you wanted. I was thinking about this and read about voltage regulators for high output stators. Could this possibly be putting out too many watts for the regulator I have?
  12. J

    Dim headlight

    I third that!
  13. J

    Dim headlight

    I will post pictures tonight. I made a pigtail to allow me to use the factory harness but since I was having issues I decided to just go to the regulator and bypass factory harness to test and narrow the possibilitys. This picture is from Google. I appreciate your help!
  14. J

    Dim headlight

    Honda motor with the tbolt 6 pole stator. I was getting 13.5 volts until everything warmed up... P.s. I tried ordering a fender from trailbuddy but every time I would try to pay it would say missing information even though there wasn't anything missing.
  15. J

    Dim headlight

    Hmmm now I'm confused. What do I do with the white wire coming from the stator then?From stator To voltage regulator I had White to 1st yellow on regYellow to 2nd yellow on reg t'd in to lightsGreen to greenRed to battery
Top