kirrbby's Recent Activity

  1. kirrbby replied to the thread K3 battery box protector/cushion.

    There are 2 different sizes of battery boxes, and plastic liners. The smaller liner is available new, the big one is not. You'll be...

    Jan 14, 2019 at 6:35 PM
  2. kirrbby liked racerx's post in the thread K3 battery box protector/cushion.

    Welcome aboard! Your K3 battery box is close to the same size as the early K0 (later K0-K2 had a smaller unit) but it should have a...

    Jan 14, 2019 at 6:32 PM
  3. kirrbby attached a file to the thread Electrical issue. It's not there.

    [ATTACH]

    IMG_20190107_195044269.jpg Jan 14, 2019 at 6:27 PM
  4. kirrbby replied to the thread Electrical issue. It's not there.

    did you plug those greens together at the ignition switch?? then clean the switch, sand to bare metal on the inside of the frame, where...

    Jan 14, 2019 at 6:26 PM
  5. kirrbby attached a file to the thread '78 CT70 Carb Rebuild.

    Also, maybe check under the rubber boot. [ATTACH] Make sure the cable is properly seated into the brass adjuster, and not bumping...

    IMG_20190114_170944211.jpg IMG_20190114_171545798.jpg IMG_20190114_171610722.jpg Jan 14, 2019 at 5:22 PM
  6. kirrbby replied to the thread '78 CT70 Carb Rebuild.

    The long thin slit goes OPPOSITE the idle screw, not facing it.

    Jan 14, 2019 at 5:01 PM
  7. kirrbby replied to the thread Exact matching Numbers KO.

    Agreed. The information has to be out there, but probably written and discussed in a verry foreign language. When I was reading up...

    Jan 14, 2019 at 9:37 AM
  8. kirrbby replied to the thread Exact matching Numbers KO.

    All I'm really doing is imagining how I might do it, if I were running the show. How would you do it?

    Jan 13, 2019 at 8:37 PM
  9. kirrbby replied to the thread Exact matching Numbers KO.

    In my scenario...at the end of a run of bikes/numbers...there is a excess of engines...no more frames. The last vin # used was 100500....

    Jan 13, 2019 at 8:34 PM
  10. kirrbby replied to the thread Exact matching Numbers KO.

    Scrap. It's cheaper, faster, easier to make a new frame, than to repair one that is welded together poorly...painted poorly, etc. A...

    Jan 13, 2019 at 7:51 PM
  11. kirrbby replied to the thread 1991 CT70M - Did some work - now NO SPARK - Help.

    Have you checked the valve lash. It's very common on a old bike to have never had the valves adjusted. Then as soon as they wear to...

    Jan 13, 2019 at 4:36 PM
  12. kirrbby replied to the thread Exact matching Numbers KO.

    We have NO lines here in the metal fab that only make one part. They swap in different dies and tooling, multiple times per day...truck...

    Jan 13, 2019 at 2:13 PM
  13. kirrbby replied to the thread 73 T90 no neutral light and no spark!! Any suggestions?.

    b52bombardier1 is the resident ST90 guy. I imagine he will be piping in to help you when he sees your post. But I've "heard" him say,...

    Jan 13, 2019 at 12:04 PM
  14. kirrbby replied to the thread Exact matching Numbers KO.

    I would think there could have been multiple opportunities to start with a matched bike. I guarantee Honda didn't build a CT70 plant,...

    Jan 13, 2019 at 11:57 AM
  15. kirrbby replied to the thread Too much crap.

    Hi Lilwildcat13, and welcome to lilHonda. I don't have a single Saphire blue frame, and I don't think I've ever had one, or a CT70 in...

    Jan 13, 2019 at 6:57 AM