Separate names with a comma.
Are you checking compression with the throttle held wide open?
Once upon a time not so long ago, it took about three weeks. I guess the 'Rona virus has really slowed things down.
Yes, it comes off. And it will need cleaning and re-lube once it has been removed. Here's the 50-50 chance you can go wrong. Mark the assembly...
Tires? Here you go.
The Motorcycle Superstore might also have a few.
Have they cashed your check?
Very little benefit other than the new primary wire and insulation ending any worry about plug wire arcing.
I'd put the chain guard on and run it. The chrome on those fenders will clean up and the whole bike will look nice again. Make sure the brakes...
Only one out of my seven old Honda bikes got the full bare metal paint treatment. But I love 'em all, new paint or old.
Brake Kleen in the red can.
If it comes down to it, I will sell you my spare ST90 engine before you spend that kind of money on one gear. Its a 1975 motor with three-up...
Your engine can't be worse than what was found in one of my ST90 engines.
I'm afraid they would throw me in jail these days to ever watch a Clayton Bigsby video again. Funny yes, but too hot to handle . . .
Yes, definitely get a NIOSH-approved cartridge mask. These paints generally contain an isocyanate type of chemical which is horrible for our...
I'm not sure that would matter unless that lamination chopped a coil wire during the act of being bent. Hard to tell from this angle. Your...
My 73 Mighty Green ST90 got sand blasted down to bare metal inside and out. The few rust pitted areas then got a touch of Bondo and sandpaper...
It has been a while since I have done that job but it appears to be straightforward. I will try to look at one of my engines later today.
Most of my 90 CC engines here have some oil on that side of the engine and I'm unconcerned about it. My case seals / gaskets and shifter shaft...
Oil at the stator? I would not worry about it as long as the case and shifter seals are good. [ATTACH]
Check for continuity per the...
My bet is that it is still a bad ground. These fifty year old wire harnesses look good at the connector but often have few or maybe even only one...
Yes, absolutely factory. All the same on my 74 and 76. The welds all look like something I might have done in high school shop Metals Class.