Separate names with a comma.
A long shot, but does anyone have a non-rusted-out CM91A muffler (18300-046-000 or 18300-046-010) sitting around? Or at least pieces that could...
Have you changed tires/tubes?
Can you post a VIN?
From what I have seen, NGK was the king of spark plug caps ("noise suppressors"), and most bikes have NGK or unmarked caps from the factory, but I...
Haven't seen this posted here, but TORC has a helmet named '1978'... I wonder where they derived their inspiration for the design and name.......
Are the bullet connectors on a factory CT70 wire harness 3.5mm or 3.9mm? I'm assuming 3.5 like most of the other Honda's, but wanted to be sure....
Dang I dropped the ball on this one! PM being sent Allen!
I never received a response here or on their website, so I never bothered to order one.
Hey FastestGrass, I've done a bit of investigation over the years and came up with the same conclusions: the CM91A is different from the CM91...
Bingo! It hadn't dawned one me to see if they still had the splines. Splines are not present and the tube has been notched to allow the tightening...
Thanks. The mounts are the same, they both bolt up, hence my confusion. The short one came off of an original '77 I parted out and the long one I...
So I have two rear turn signal stays, both are black, both fit my 78', but they are two different lengths. o_O I'm not sure what the proper length...
So late last night I remembered that one of the bikes I picked up years ago had a PZ19 carb on it. I took it apart and it is almost a direct fit...
The later model carbs seem to sell for more, idk. Here is another forsale for $119 that needs some help: Vintage 1978 Honda CT70 Trail 70 Keihin...
Yeah, not sure what model number a 77 would be, but it should have a square bowl like previous models. As luck would have it, I received the...
Thanks for that, I had forgotten to check Beatrice! Yeah, next step would be a PZ19 if the OEM carb ($25 shipped) doesn't work out - I don't mind...
I had wondered about that but would use that as my very last resort. However, I just scored a mostly complete PB37 on FleaBay that was incorrectly...
Looking for the top half of a PB36 or PB37 for some parts. Mainly I am looking for the spring that sits between the choke cap and the choke lever....
There was a running, CA titled one on eBay about a year ago. It continuously never sold, last price on if I recall was $1700 with no takers.
From Honda Worldwide: Super Cub Anniversary Vol. 1 — The Birth http://world.honda.com/supercub-anniv/story/ SUPER CUB Anniversary Vol. 2 —...
