Separate names with a comma.
Engine is done but I forgot to order a clutch cover gasket. Doh. Moving on to disc fork install. Anyone have a link for getting the aftermarket...
Appreciate the link. Drilled the oil port to 2mm now putting the top end back on and I'll be ready for a new oil pump. Oil slinger cleaning too...
Yep, definitely cleaned that gasket material some more. I'm going to drill out the oil port 2mm before I put the top end on and order a high flow...
Been working on her most of the day, going well. Cam and rocker arms look real good so I'm using those. Barely any lateral crank play. Got rings...
Thanks for the feedback kirrbby, engine is off the old bike and starting with a good inspection and getting it as clean as possible while its not...
What I'm looking for is some guidance on the top end rebuild.
Hey all, new to the forum and wanted to start a thread on my CT as I've got ALOT to do and will definitely be needing some help along the way! I...
Oh the neighborhood was ripped for sure. I did exactly that with the bucket and found a couple terms unplugged. What is recommended as a good...
I noticed that and have learned the hard way from other bikes. Gonna go with the recommended above.
Well I have to take back everything I said about hating it. After my meltdown I went back later last night. It started, I rode it, and as you all...
Hey all, new to the forum. Just picked up a 70' HKO and was super excited, so far I hate it haha. Have spark and enough compression to start....
