fatcaaat
Well-Known Member
Ok. I would never sell a motor unless i was confident it would be a great motor. I have been considering building a leftover parts motor but unless someone is interested ill just keep as spares.
This would be 95% honda as follows.
Honda nice engine cases, oil pump, head, crank, shifter, kickstarter.
Trx90 transmission and clutch. Chinese stator. Some misc Chinese bits. Same as i use on personal builds.
I can configure as a 52, 54, or 56 bore . 52 is chinese, 54 and 56 are custom i had done. and would be built obviously with all new gaskets, seals, bearings, rollers, cam chain etc. i always use Japanese german or french bearings.
To build and offer id be about 1400-1600 depending on the final configuration and it would look like a new engine.
Dipping the toe here. I could even configure as a semi auto but that means a chinese crank with honda rod and bearing. I have taken a yx140 crank and put in honda bits and machined it for balance a trueness.
This would be 95% honda as follows.
Honda nice engine cases, oil pump, head, crank, shifter, kickstarter.
Trx90 transmission and clutch. Chinese stator. Some misc Chinese bits. Same as i use on personal builds.
I can configure as a 52, 54, or 56 bore . 52 is chinese, 54 and 56 are custom i had done. and would be built obviously with all new gaskets, seals, bearings, rollers, cam chain etc. i always use Japanese german or french bearings.
To build and offer id be about 1400-1600 depending on the final configuration and it would look like a new engine.
Dipping the toe here. I could even configure as a semi auto but that means a chinese crank with honda rod and bearing. I have taken a yx140 crank and put in honda bits and machined it for balance a trueness.
