Anyone know this part number ST70 carb to manifold o ring

[Holla]

Hi all, does anyone know the part number for this o ring that sits between the inlet manifold and the carb?

Thanks

 

[lukelaw1]

@ *INTAKE MANIFOLD ORING 27MM_X_2MM 91301-GK4-871 1/20M (R2102)

dratv.com

should be right

 

[Holla]

@ *INTAKE MANIFOLD ORING 27MM_X_2MM 91301-GK4-871 1/20M (R2102)

dratv.com

should be right

Thanks, but dies it not need the cutaway where it goes over a hole?

 

[Midnightpromises]

No

 

[kirrbby]

X2 No, it's just a o-ring.

 

[OLD CT]

Go on amazon and buy an o ring assortment kit.

 

[Midnightpromises]

Go on amazon and buy an o ring assortment kit.

And it won't have the right size ...

 

[OLD CT]

If you look hard enough you will. 10 pack delivered for less than dratvs shipping...

 

[Midnightpromises]

If you look hard enough you will. 10 pack delivered for less than dratvs shipping...

That's the correct size ,they're usually not in those assortment kits

 

[OLD CT]

Correct! I looked at the kits and the 27's are 3mm thick. Not good... Nice that they give the exact sizes written now when you open the kit, then I narrowed the search and found em cheap. Now Holla has a lifetime supply.

 

[Midnightpromises]

Correct! I looked at the kits and the 27's are 3mm thick. Not good... Nice that they give the exact sizes written now when you open the kit, then I narrowed the search and found em cheap. Now Holla has a lifetime supply.

Yeah, took me three kits to figure out that that was a waste of time and money.