crf xr exhaust on a ct??!!??

[dano]

has any one ever tried an putting an after market exhaust for a crf 50,70 or xr 50 70 100 on a ct70 i was thinking about trying it. also wondering if after market offroad exhuasts are street legal ?

 

[jeremy kohler]

Stop Lettin Your Friends Buy All The Stuff And Step Up And Buy Some Gear And Always Rember Fat Crickets Need Love Too.

 

[Beedo]

You Ohio folk are just crazy.

Here is an exhaust for ya

 

[CTdave]

I bet that flows. love it.

 

[69ST]

Not my cuppa Starbucks, but what the hey. Bet that bike has better cornering ability in righthand turns

I've seen all manner of non-stock exhausts used on CT70s (ST70 Daxes, actually). Usually it just requires a custom hanger. Two caveats: the low-mount type will interfere with the buddy pegs and most all are lacking in the area of heat shielding. That won't set the bike ablaze, but either someone's leg can get slow-roasted or you'll end up burning a hand/arm while working on the bike at some point

 

[DoubleR Dan]

This must be the 3rd or 4th thread about this.

I put a stock XR50 pipe on mine - but I also have an 88cc kit and 20mm carb - it flies, rips, etc.

 

[dano]

what kinda mods did ya have to do to fit the fiddy pipe? im runnin a 125cc i need some flow!!

 

[TrailPunisher]

The stock XR-70 Pipe can be modded,
I replaced the restrictive stock endcap with this aluminum one and installed the screen type spark arrestor on my XR and CRF-70 bikes with Zongshen engines.
http://pg.photos.yahoo.com/ph/punisherjbracing/detail?.dir=e622&.dnm=bfbcre2.jpg&.src=ph

 

[dano]

The stock XR-70 Pipe can be modded,
I replaced the restrictive stock endcap with this aluminum one and installed the screen type spark arrestor on my XR and CRF-70 bikes with Zongshen engines.
http://pg.photos.yahoo.com/ph/punisherjbracing/detail?.dir=e622&.dnm=bfbcre2.jpg&.src=ph

so im assuming im gonna have to move the upper mounting tab back or forth to fit a crf or xr pipe on the ct ?!

 

[DoubleR Dan]

what kinda mods did ya have to do to fit the fiddy pipe? im runnin a 125cc i need some flow!!

all I did was grind the the one weld and then line it all up with the header bolted up and then make my marks. Then I had a welder weld the bracket up. I took the bike up there so that he could make sure it was all straight.


It was like 15.00 to get it welded.

Then high heat flat black paint.

Then I took off the stock tip and put a 50stunt.com power tip on it.

 

[OLD CT]

pipe

Nice job! that goes to show what u can do with a little creativness.