Separate names with a comma.
Discussion in 'FOR SALE on lilHonda' started by kirrbby, Feb 19, 2013.
Also need a 1970 4 speed speedo. Thanx
All 3 seal plenty well enough on the tank. All 3 need new rubber.
1 and 2 have some visible ugly in the off position. Missing chrome and or...very shallow, dents.
1 looks best...shiny chrome. Few light scratches.
3 looks like it may have been over polished...maybe to remove rust... Kinda looks like some underlying dark stains. Still looks pretty good tho and basically clean on the bottom side.
2 looks pretty nice and should clean up better. Chrome has a little more texture to it tho. More rust on bottom side, but it's nothing to worry about.
I haven't cleaned any of these...this is, as received.
Zoom in look close.
I'll pm prices so as not to shock anyone.
1 and 3, $65
Shipped... first class mail.
All prices are based on, how much "I" like the part. (Pretty much a rule)
Hi, I am in need of a complete ct70h ko engine and front forks for a 1970 model if you have them. Thx!
Are you wanting a running engine, or a core to rebuild??
Given my current skill level, a running engine is preferred if available. How much is a good one?
Kirrbby are those z50 gas caps? or were the metal tanked 70's the same? Which ones do you still have? Thanks
Those caps came on CT70's 69-about 79.
And Z50s from Midway K1 thru about 79..?
The earlier Z50s had a slightly different version of the same cap.
I still have all 3 from post #1022
I'm not going to have a running engine to offer. I think I only have one lower end. I bought it that way and don't know anything more than what I can tell by checking it over. I could add a cylinder and head to make it complete. These engines are expensive tho...probably $300-350 just for a good core.
You might want to post up your bikes Vin # 1st 4 or 5 digits at least in case someone might have a close # engine or case to offer you. I have found H engines to match frames twice before.
I also have lots of parts to build CT70 engines from scratch. That would probably be even more expensive tho. But it might be a option.
I assume your bike didn't come with a motor of any kind..?
I knew it would be a challenge. Actually, I do have a running sl70 engine on it now and a 73 or 74 model frontend I want to change out to a correct one. Thx for looking!
Any chance you have a Topaz swingarm for 73-74 CT70 in reasonable original condition?
4-gear I'm going to have to say no. The only one I have I was saving for a project. I would have to sell it high, then try to replace it down the road.
I will keep a eye open for you tho. They come across eBay now and then.
This might be one too.
Thanks for the reply. I will give those a look.