Latest activity

Hello all, I bought this bike two weeks ago and when the previous owner started the bike, he kick started because it needed a battery. I...

I put the seat as low as i could. This is tge final product now.

Its a cz100 honda engine. So the shape is just early. The running issue was resolved by replacing the condenser. The carb gets warm...

Done but I’ll recalibrate the seat position. Going to sell it.

Done but I’ll recalibrate the seat position. Going to sell it.

This is what I found in my Clymer manual. HTH.

35 ft lbs is what I set the wrench at. Same for the clutch.

My Clymer manual goes by bolt size and thread pitch. I usually snug down with impact driver but you definitely don’t want to strip those...

35 ft lbs is what I set the wrench at. Same for the clutch.

35 ft lbs is what I set the wrench at. Same for the clutch.

This is what I found in my Clymer manual. HTH.

This is what I found in my Clymer manual. HTH.

I'm a new member looking for sites that sell parts. I'm the original owner of a 1971 SL 70. Rode it as a teenager and held on to it. Now...

Did you ever figure this out, as I have the same problem on my 1974 CT70. It was working fine until I took off the cover to repaint it...

I've had very good luck with 4mm old school VW braided rubber fuel line. Hose clamps rarely needed.