Search results

Just ordered it. I will keep you guys posted once it arrives and I get it installed.

Are you saying I should cut one out of a gasket material sheet to fit?

Yes I did remove it and manually stuck a thin wire through all the ports and sprayed it thoroughly with carb cleaner.

I forgot to mention I have gone through and cleaned the carb twice now. But it has come to my attention that there is still an intake leak. I am still trying to wrap my head around how there could be one still, but none the less there is. I had to repair the threads in the cylinder head on...

Hey friends! I have a 1979 Honda ct70 that runs and rides perfectly fine, but the idle fluctuates and will stall out unless I give it a little throttle. I have already addressed the intake leak at the manifold and the problem still prevails. No matter how I fine tune and adjust the idle screw...

Update, I went to the hardware store this morning and picked up a new o-ring for the intake. All seemed to be going well until I went to install the intake manifold with the new o-ring onto the engine and the threads stripped out of the cylinder head on one of bolt holes. :rolleyes: After some...

I was just wondering this for my girlfriends rear shocks! It is looking like our best route would to be just to buy some new rear shocks with adjustable damping.

Thank you for the Input friend. I will pick up a new O-ring tomorrow morning! The Jet Needle that I currently have in the carb only has 1 notch, but I believe if I put small washers underneath the c-clip it will have the same affect. I do have the insulator block on the other side of the intake...

My 1979 Trail 70 has been running and riding pretty well up until I disassembled the carb, cleaned it, and put a new air/fuel mixture screw in. The previous owner had plugged the air/fuel mixture screw port with a metal cap as the carb was missing the screw completely, so I figured I would order...

The bike turned out phenomenal! I love the color scheme, great looking bike.

Nice find! Are you still riding it after all these years? Haha.

Oh man, I didn't even realize that was supposed to be a screw, haha. I will have to look into getting another screw to replace that. I don't even know how that happened or why it looks like that.

My engine is running a little lean on my 1979 ct70 and I am struggling to find the air screw (if I even have one)? I realize the screw in the middle of the carb directly below the throttle cable is the idle adjustment screw, but that is the only screw I am seeing that adjusts the carb. Am I...

Just picked up my 1979 a few days ago, super stoked! The previous owner collected them and was downsizing his collection, the bike runs pretty well and is mostly complete with (almost) everything working. This is my second trail 70, with my first one being a 1972 I sold over 2 years ago and have...

I might just end up purchasing the wiring harness from trail buddy once trail buddy opens back up, since there only about 20 minutes away from me. I'm looking to have a headlight and taillight for now.

So for my headlight to work I would be better off getting a higher voltage bulb? There's a cdi that came with the engine thats connected to the killswitch, does that regulate voltage so I can utilize my 12v bulb? Also, if I do get a higher wattage bulb, if the engine goes under the voltage of...

Would I be able to wire up my headlight by utilizing a 12v resistor and just installing that in the power line to the headlight? I have one pictured below.

Ok, ill go ahead and order that sprocket. 20mm is the correct center size for a 125cc Lifan correct?

So I got both the sprockets off and it turns out that the 420 chain sprocket I have is too small in the center hole to fit on the new engine. How do I know what size sprocket to purchase in order to fit my engine?

Tips on removing the drive sprocket? How exactly is it attached. There are 2 bolts on the outside of it.