Search results

Anyone happen to have a pic? Thanks :10:

Mee three! 6 digits = KO. :scooter:

Haha yup you got it red! I just read an article on how our province and specifically the Greater Toronto Area pays the highest rates in all of North America! Pure BS!! Oh and 6 month policies don't exist in Onterrible!!

I just got insurance(yesterday) through State Farm for $350/yr. I have had my full M for 4 years now but never insured a bike before, which is why it's a little higher but other than that I have a clean record. The agent needed to see a copy of the ownership to verify if the VIN did or did not...

I've been eying those up spizz how much was shipping?

Looks like a great start! Was the HOK from a rattle can or did you order a quart?

I saw a post on one of the FB pages that CHP is selling some bikes to free up capital for another project...

What clamps did you end up going with and what did you have to do to the 15mm axle to make it work. Wrapping my head around it slowly, I've wanted to adapt a similar fork for my rider project. My initial thoughts were towards a marzocchi shiver style fork with a brembo dual pot caliper. I am...

Very nice work! I'm loving the setup! Newb question, why doesn't a crf clamp work? Too narrow? What clamp did you have to get in order to make it work?

Hahaha worst advise possible, "sell the good parts" to buy another frame so then what you have no parts... :21: That frame looks toast but if it's ready garbage you might as well give it a shot and like others have said possibly learn a little something

I have a K1 that I'm making street legal, bought a k3 harness and K3 3 position switch and so far so good! Here's the switch I picked up, according to dratv it works for k1-76 http://dratv.com/igkeyswctk1t.html

GTA Ontario

Darrel did you drill out the threads on the petcock to mount it? Randy, build is looking great! Did you order from chp or a local dealer?

Excellent guys! Thanks for the replies, I'll try the grinder for now and possibly down the road upgrade to a dedicated buffer

Looks amazing Tim! What paint are you using to match the cloud silver?

So the PO on my CT70 painted just about everything and I would like to remove the paint and put a polish back on where I can. Question is would you suggest converting a bench grinder with a polishing wheel or buy a dedicated buffer? I currently have a 6in 2.8A 1/2hp bench grinder.. Initial...

Nice work! Turing into a nice little rider! What front set up is that? How do you like it? I am thinking of getting a set for my commuter bike

Thanks tips! Opinions are like farts, just because you have one doesn't mean you have to let it out. I am well aware of what forums are all about and opinions will come from everywhere even when they aren't asked for.

Nice build! Seems to be a lot of purists on this forum who won't like change but it's your build and looks great! How have you found PC'ing your own parts? I was contemplating picking up a kit as well and trying some. Those tires are Michelin boppers, a scooter tire. I've put the same ones...

Funny how a guy in the desert posts the article... Sorry Adam but those in the snow belt and great white north will tell you there's a huge difference when you let a vehicles water temp/oil temp rise. Me personally I am fortunate enough to work less than a ten minute commute from home and in the...