Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
Members
Registered members
Current visitors
New profile posts
Search profile posts
Donations
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
General Minitrail Talk
Modifications
Adding a LED to an aftermarket large housing.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="allenp42" data-source="post: 185110" data-attributes="member: 8785"><p>I wish I had never looked at the picture......</p><p></p><p>Easy part first. Do you still show 300 ohms on the coil for the CDI? If not, correct this and you should have ignition again. </p><p></p><p>Now on the part that makes no sense. See attached pic for my questions. </p><p></p><p>Appears that you have 2 wires going to Coil A, then a single wire going to coil B, then a single wire going to coil C and other end of coil C is grounded? That's what I see but just want to confirm before going any further and tossing out ideas. </p><p></p><p>Worst case, you can send the lighting coil to me and I'll re-wind it for you. I have about 75 feet of wire but not sure what gauge you have. If you have an accurate caliper, see if you can measure the diameter. It's probably some where between in the range of 0.8mm.</p></blockquote><p></p>
[QUOTE="allenp42, post: 185110, member: 8785"] I wish I had never looked at the picture...... Easy part first. Do you still show 300 ohms on the coil for the CDI? If not, correct this and you should have ignition again. Now on the part that makes no sense. See attached pic for my questions. Appears that you have 2 wires going to Coil A, then a single wire going to coil B, then a single wire going to coil C and other end of coil C is grounded? That's what I see but just want to confirm before going any further and tossing out ideas. Worst case, you can send the lighting coil to me and I'll re-wind it for you. I have about 75 feet of wire but not sure what gauge you have. If you have an accurate caliper, see if you can measure the diameter. It's probably some where between in the range of 0.8mm. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
General Minitrail Talk
Modifications
Adding a LED to an aftermarket large housing.
Top