Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
Members
Registered members
Current visitors
New profile posts
Search profile posts
Donations
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
General Minitrail Talk
Wanted/Looking For
OEM Honda cylinder # HM-A2
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="kirrbby" data-source="post: 184316" data-attributes="member: 3972"><p>I had to hone this cylinder for...maybe a total of about 4 minutes to get some score lines out. They were down in the spigot area. Then I had to make a quick pass with a dry hone in my cordless drill to get a little cross hatching. I think it looks good, but maybe someone else could pipe in about the cross hatching...does it look adequate??</p><p></p><p>A machinist friend did some measuring. He came up with 47.04-47.06mm around the top of the bore, and 47.00mm at the bottom/spigot end. Are those numbers good??</p><p></p><p>I blasted it clean before I honed it. At this point I'd just spray it down with WD-40 and ship it. You'd need to spray it with brake cleaner before you paint it.</p><p></p><p>I think it's a good part, ready to go. But I don't know what the service limit is for a standard bore.</p><p>[ATTACH]64190[/ATTACH] [ATTACH]64191[/ATTACH] [ATTACH]64192[/ATTACH] [ATTACH]64193[/ATTACH] [ATTACH]64194[/ATTACH] [ATTACH]64195[/ATTACH]</p></blockquote><p></p>
[QUOTE="kirrbby, post: 184316, member: 3972"] I had to hone this cylinder for...maybe a total of about 4 minutes to get some score lines out. They were down in the spigot area. Then I had to make a quick pass with a dry hone in my cordless drill to get a little cross hatching. I think it looks good, but maybe someone else could pipe in about the cross hatching...does it look adequate?? A machinist friend did some measuring. He came up with 47.04-47.06mm around the top of the bore, and 47.00mm at the bottom/spigot end. Are those numbers good?? I blasted it clean before I honed it. At this point I'd just spray it down with WD-40 and ship it. You'd need to spray it with brake cleaner before you paint it. I think it's a good part, ready to go. But I don't know what the service limit is for a standard bore. [ATTACH]64190[/ATTACH] [ATTACH]64191[/ATTACH] [ATTACH]64192[/ATTACH] [ATTACH]64193[/ATTACH] [ATTACH]64194[/ATTACH] [ATTACH]64195[/ATTACH] [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
General Minitrail Talk
Wanted/Looking For
OEM Honda cylinder # HM-A2
Top