Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
Members
Registered members
Current visitors
New profile posts
Search profile posts
Donations
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
General Minitrail Talk
Modifications
Trans mounted clutch... TRX90
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="kirrbby" data-source="post: 168026" data-attributes="member: 3972"><p>When I had my 124cc motor built, I asked for a manual clutch. Terry's plan was to just add a hydraulic clutch slave cylinder that would disengage the trans mounted clutch. The one way/centrifugal clutch would stay. It would still disengage at low rpm's and idle in gear etc. But at speed, you would ride and shift it like a manual clutch setup...you wouldn't have to allow the rpm's to drop before shifting, since you could disengage the main clutch with the hand lever. </p><p>This is the slave cylinder...it would go into the bearing on the clutch, and it mounts in the clutch adjustment stud hole.</p><p>This one would take quite a bit of work to get it properly mounted.</p><p></p><p>[ATTACH=full]54971[/ATTACH] [ATTACH=full]54972[/ATTACH]</p></blockquote><p></p>
[QUOTE="kirrbby, post: 168026, member: 3972"] When I had my 124cc motor built, I asked for a manual clutch. Terry's plan was to just add a hydraulic clutch slave cylinder that would disengage the trans mounted clutch. The one way/centrifugal clutch would stay. It would still disengage at low rpm's and idle in gear etc. But at speed, you would ride and shift it like a manual clutch setup...you wouldn't have to allow the rpm's to drop before shifting, since you could disengage the main clutch with the hand lever. This is the slave cylinder...it would go into the bearing on the clutch, and it mounts in the clutch adjustment stud hole. This one would take quite a bit of work to get it properly mounted. [ATTACH=full]54971[/ATTACH] [ATTACH=full]54972[/ATTACH] [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
General Minitrail Talk
Modifications
Trans mounted clutch... TRX90
Top