Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
Members
Registered members
Current visitors
New profile posts
Search profile posts
Donations
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
General Minitrail Talk
Modifications
Trans mounted clutch... TRX90
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="fatcaaat" data-source="post: 169377" data-attributes="member: 1656"><p>Instead of the button screws that hold the plate on for the oil spinner, I took the plate, and added a angled recess to it and then put flush bolts in there. I also ground off a lot of the lip that goes around it for clearance. That lip adds some regidity, but it doesn't need it...there's no pressure on that thing. So if you need clearance, you can cut that down quite a bit.</p><p></p><p>As for your throw...there's more than one way to deal with that. You can find a thicker bearing, you can replace the throwout cage entirely and replace with a Honda Nice version (bigger and thicker bearing), you can machine a 2-3mm ring and put it in before the bearing. </p><p></p><p>I think when I built my poor man's nice, I ended up using a honda nice cage and bearing instead of the stock trx90 one. I also once busted a honda nice one and replaced it with a TRX90 one and had the same issue with throw. I eventually replaced the cage with the Nice one.</p></blockquote><p></p>
[QUOTE="fatcaaat, post: 169377, member: 1656"] Instead of the button screws that hold the plate on for the oil spinner, I took the plate, and added a angled recess to it and then put flush bolts in there. I also ground off a lot of the lip that goes around it for clearance. That lip adds some regidity, but it doesn't need it...there's no pressure on that thing. So if you need clearance, you can cut that down quite a bit. As for your throw...there's more than one way to deal with that. You can find a thicker bearing, you can replace the throwout cage entirely and replace with a Honda Nice version (bigger and thicker bearing), you can machine a 2-3mm ring and put it in before the bearing. I think when I built my poor man's nice, I ended up using a honda nice cage and bearing instead of the stock trx90 one. I also once busted a honda nice one and replaced it with a TRX90 one and had the same issue with throw. I eventually replaced the cage with the Nice one. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
General Minitrail Talk
Modifications
Trans mounted clutch... TRX90
Top