Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
Members
Registered members
Current visitors
New profile posts
Search profile posts
Donations
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
General Minitrail Talk
Modifications
Trans mounted clutch... TRX90
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="kirrbby" data-source="post: 169386" data-attributes="member: 3972"><p>I opened it back up and swapped the kickshaft. I put the dratv TRX90 kickshaft kit in. The doc gives some instruction on how it should be installed, but it was kinda weird and unclear to me.</p><p><a href="http://dratv.com/tradkistas.html" target="_blank">http://dratv.com/tradkistas.html</a></p><p></p><p>It comes with 2 different thrust washers. A 17mm and a 20mm. In my opinion, the 17mm needs to go on to the shaft, on top of the spiral cut gear, before you put the right side case back on. This is similar to how the CT70 setup is. The washer protects the engine case from the spiral gear, and holds the shaft in place. Then the right case goes on. Then the spring and retainer. Then the snap ring. (Dratv didn't include a snap ring in the kit.)</p><p></p><p>The doc shows the 20mm washer going in UNDER the return spring. I don't think that's right, or necessary. It's just too big and sloppy in there, and not needed. </p><p></p><p>This is a nice part IMO, just leave the bigger washer out, and order a new snap ring. </p><p></p><p>The first pic is of the old shaft Thai I took out.</p><p>[ATTACH=full]55896[/ATTACH] [ATTACH=full]55897[/ATTACH] [ATTACH=full]55898[/ATTACH]</p></blockquote><p></p>
[QUOTE="kirrbby, post: 169386, member: 3972"] I opened it back up and swapped the kickshaft. I put the dratv TRX90 kickshaft kit in. The doc gives some instruction on how it should be installed, but it was kinda weird and unclear to me. [URL]http://dratv.com/tradkistas.html[/URL] It comes with 2 different thrust washers. A 17mm and a 20mm. In my opinion, the 17mm needs to go on to the shaft, on top of the spiral cut gear, before you put the right side case back on. This is similar to how the CT70 setup is. The washer protects the engine case from the spiral gear, and holds the shaft in place. Then the right case goes on. Then the spring and retainer. Then the snap ring. (Dratv didn't include a snap ring in the kit.) The doc shows the 20mm washer going in UNDER the return spring. I don't think that's right, or necessary. It's just too big and sloppy in there, and not needed. This is a nice part IMO, just leave the bigger washer out, and order a new snap ring. The first pic is of the old shaft Thai I took out. [ATTACH=full]55896[/ATTACH] [ATTACH=full]55897[/ATTACH] [ATTACH=full]55898[/ATTACH] [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
General Minitrail Talk
Modifications
Trans mounted clutch... TRX90
Top