Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
Members
Registered members
Current visitors
New profile posts
Search profile posts
Donations
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
General Minitrail Talk
Tech Area
Valve clearance points and carb
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="hrc200x" data-source="post: 196076" data-attributes="member: 152"><p>Middle notch with the clip is usually factory setting, you can raise the clip which would lean the mixture. Also the external pilot screw is usually around 1 1/4 turns out from lightly seated. Float level is important but I rarely need to adjust it. From another site it says to do this to set float level. 18mm with the float hanging straight down, tang just touching the valve pin</p></blockquote><p></p>
[QUOTE="hrc200x, post: 196076, member: 152"] Middle notch with the clip is usually factory setting, you can raise the clip which would lean the mixture. Also the external pilot screw is usually around 1 1/4 turns out from lightly seated. Float level is important but I rarely need to adjust it. From another site it says to do this to set float level. 18mm with the float hanging straight down, tang just touching the valve pin [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
General Minitrail Talk
Tech Area
Valve clearance points and carb
Top