RadRacer203
Active Member
So a bit of backstory- I got this '79 ATC 110 from a guy in New Jersey for $50 a couple years ago. Fixed it up with new tires and miscellaneous maintenance and it was running absolutely perfectly and was so much fun! I've been riding it up until about 3 months ago when the original clutch finally gave up ,and I decided to replace everything that could be worn in one go. I was away for a while after that so I rebuilt it about 2 months ago. I put in new springs, plates, friction plates, and a new gasket. After I got it back together I was trying to adjust the clutch and it would miss shifts and just generally feel like crap going through the gears. I managed to get a shop manual from someone down the street and I realized I had stupidly put the friction plates in dry and put a spring in the wrong place. So I got frustrated and walked away until today. I had gotten some new friction disk and a new gasket, and soaked the disks in oil for a full day before putting them in. I followed the manual to the letter, got everything back together, and it shifts like crap again. Is there anyone in the New England area that can help me? I really need some help from someone more experienced than I am. I know I didn't screw anything up too bad, checked everything over for wear and damage before assembling it. I'm pissed off at myself, pissed off at the bike, and about ready to push it off a cliff and I could really use a hand cause I'm at my wit's end.