here is mine - it shows some of the mods that I did to it.
Moved the bracket back & re-welded it, then welded the center bracket to the pipe - so it basically is bolted and supported in the middle. then added a peice of flat steel and welded a threaded spacer part off the xr50 pipe for the front part of the CT70 gaurd to bolt to (mine was missing the clamp to it anyways).
then I used the original thearded spacers off the CT70 pipe and welded them on the XR50 exhaust canster so that the two rear screws lined up. Then used another peice of flat steel and threaded spacers (off the CT70) and welded it on the tube part of the XR50 pipe.
Also - I had to custom bend the CT70 guard so that it somewhat matched the flow lines of the XR50 pipe.
It was pretty easy and looks pretty clean and saved me from buying a high dollor pipe = for now.
The complete pics are on this thread.
http://s87907731.onlinehome.us/webboard/showthread.php?t=12&page=3