K-1 and up speedo disassemble

[scooter]

2.6065

 

[Robert thran]

Hey Bob I found a speedo that I can open up and remove face and mail you..if you think that would be easier or better?

 

[red69]

Hey Bob I found a speedo that I can open up and remove face and mail you..if you think that would be easier or better?

Yeah, that might be better. In the meantime I'll keep working on this one. Keeps me out of trouble. I'll send you a message.

 

[red69]

The one I'm working on is a 4-speed.

 

[red69]

Here's the 4-speed. What do you think?

 

[Robert thran]

Hey Bob I got the face plate off..it’s in prefect condition …I’ll get in the mail sometime this week.

 

[red69]

Okay, good deal! By the way, that face plate looks perfect.

 

[Robert thran]

Okay, good deal! By the way, that face plate looks perfect.

Hey Bob I just discovered the face plate in the earlier pic is a Honda brand speedo (identified by the H symbol at the bottom of face plate) that came on k-3’s ( maybe k-2’s) the nippon seki speedo came on the k-1’s and after really looking close there’s major differences..one being the two small mounting screws are slightly higher up on the nippon seki second there’s no shift numbers 1-2-3 on the nippon seki,, third not that it matters on the over lay but the high beam indicator is blue not red..I’m going to dig around and see if I can find a clean nippon seki face and I’ll send you both…the pic shows the nippon seki on the left ,,it a 4 speed but could be covered to be a 3 speed Or you could use for a four speed decal guide? I’ll keep you posted..thanks

 

[red69]

Also the "MPH" on your Honda face plate is lowercase. The scanned Honda 4-speed face plate that I have utilizes uppercase letters.