420 front sprocket

cap279

cap279

Member
Were can I get a 20mm spline 420 tooth ratio front sprocket to match my Lifan engine with my stock rear honda sprocket, or a rear 428 ratio sprocket that will fit a honda hub. Raplies can be forwarded to cap279@msn.com
Many thanks,
Chad
 
katseye

katseye

New Member
Sprocket

Check out hooperimports.com under engine add ons. They had one for my conversion and it works fine. Good luck! :D katseye
 
6

69ST

Well-Known Member
No one makes a #428 pitch CT70 wheel sprocket. There are basically two options: switch to a Z50-type hub, for which there are a few sprockets available in this pitch - or - machine an adapter for a CT70 hub. Either setup will likely also require having a wheel sprocket machined as well.
 
cap279

cap279

Member
sprockets

Thanks for the info. I have found a rear sprocket that fit the honda rear hub at a 428 pitch from a local dealership from a ct90 of st90...something. My fault for not keeping the recipt so I have to dig again. Also, I received a reply from Motor City Mini Trails stating that they could custom produce most any sprocket for $25+ if I wait until their next big order. Always looking for the next new thing.
Many thanks,
Chad
 
Top