Rob Kammer
New Member
Hi: Just starting to put the little gem back together and I've already hit a bump. There are two steel cylinders, I'm guessing they are oil jackets and or alignment pins for the cylinder to head. I've attached a picture. They came apart attached to the cylinder and I was able to tap them out.
It seems that I should put these into the block to avoid splitting the gasket with the fat end of the tube. But when I try to tap it in it does not want to go in easily. I thought I could press it in but stopped when it would not go in easily. Didn't want to strip the threads.
Any suggestions would be very much appreciated.
Rob
It seems that I should put these into the block to avoid splitting the gasket with the fat end of the tube. But when I try to tap it in it does not want to go in easily. I thought I could press it in but stopped when it would not go in easily. Didn't want to strip the threads.
Any suggestions would be very much appreciated.
Rob