MobileAZN
New Member
When planning out this build, as I didn't get much of anything to go on for a front end, I was going to put on the inverted fork set you see for the CT70 everywhere. Seems up there at $400 (that's with shipping). So I've started looking around, and realized there are a ton of options for front ends, but I don't have the dimensions of any front end parts to really go on. I don't have a top clamp, the fork I received do not match, so I am unsure if what I have of them really goes to this 1977 CT70.
Can anyone give me the measurements I need to look for when looking at the center pole of the triple? Fork length I should look for? I am considering the 12" wheel swap if that matters much.
These are what I've found on Amazon that I'm thinking may fit from what I can gather, but I could be wayyyy off.
http://a.co/d/3QBvUe9
http://a.co/d/eu6jPCS
I know I'll still need to get a brake setup and a hub for disc and such. Any pointers would be great. Or is just buying the $400 setup the best route to go?
Can anyone give me the measurements I need to look for when looking at the center pole of the triple? Fork length I should look for? I am considering the 12" wheel swap if that matters much.
These are what I've found on Amazon that I'm thinking may fit from what I can gather, but I could be wayyyy off.
http://a.co/d/3QBvUe9
http://a.co/d/eu6jPCS
I know I'll still need to get a brake setup and a hub for disc and such. Any pointers would be great. Or is just buying the $400 setup the best route to go?