Need help - Original handle bar VS throttle with Mikuni 26mm carb

[CT70 K0]

Here is the post, with the picture of the other adjuster...

http://planetminis.com/forums/z50-ct70-jdm-monkeybikes/210662-up-running-finally.html#post2053680

great thanks, I just bought that 90 adjusted thas fits the mikuni carb. If it is too long then I will be able to cut bottom end.

 

[CT70 K0]

Just received today the 90 degre adjuster.
After measurement I had to cut 36mm from the outer throttle cable to get everything fit together. I have used my dremel for that and I had to make sure to not dammage the inner cable. it took me about 1.5 hours to get the job done.
There is no play at all in the cable and the axle from the carb seems to make the full course from close to open.

I like that result.

here is a picture:

 

[fatcaaat]

Looks clean. I usually use the 45 degree elbows but this looks great.